uber fast break-in

https://pinoyspeedcubers.forumotion.com/cubing-videos-f6/super-fast-cube-break-in-astig-to-t3218.htm

has anyone tried this... i think it'll make the screws hot enough to melt the core.... tinry ko kasi i break in ung diy ko dati uminit ung screw tas na loose thread xa... so my question is ano g pede gawin para ndi uminit ung screw..... sori kung dito ko pinost pinag mamadali na ako dito sa pc tataas daw ung kuryente e nandito ako sa off topic kaya dito ko na pinost... paki move na lang kung kailangan

skn auz naman.. ginawa ko to.. wala namang problema, naging maganda at dumulas ung cube lalo na pag nalube na ito..

wala258 wrote:skn auz naman.. ginawa ko to.. wala namang problema, naging maganda at dumulas ung cube lalo na pag nalube na ito..

wat materials did u use?

MaZtR HaXoR wrote:

wala258 wrote:skn auz naman.. ginawa ko to.. wala namang problema, naging maganda at dumulas ung cube lalo na pag nalube na ito..

wat materials did u use?

driller tapos box na inukit specialy for single layer sa 3x3x3....

amoy sunog ung cube pagtapos... haha

S a s o r i wrote:

MaZtR HaXoR wrote:

wala258 wrote:skn auz naman.. ginawa ko to.. wala namang problema, naging maganda at dumulas ung cube lalo na pag nalube na ito..

wat materials did u use?

driller tapos box na inukit specialy for single layer sa 3x3x3....

amoy sunog ung cube pagtapos... haha

wat box po? pls specify how to do and wer d get it

i think bottom of a 1.5 litter coke is better since at the bottom may part ng plastic na matigas gagawa ka na lang ng butas dun para sa tatlong grippers ng drill... i'll try it kapag may bago kong diy

that's insane!!! hahaha!!!! pero ang lufet... hmm.... para maiwasan ang overheating(try mo to baka effective...), ask an assitant to pour some cold water while doing that "break-in"
para di masyadong uminit yung screws while spinning at high speeds.... eto p pala isa, kung meron kang grease na pang high temp (like ung ginagmit sa mga bearing ng kotse) lagay mo sa screws then spin it like hell... mangingitim nga lng yung loob ng center cap mo dhil sa nasunog sa grease, pero safe na safe ang cube mo... linisin mo n lng pagkatpos... peace out!!!

MaZtR HaXoR wrote:

S a s o r i wrote:

MaZtR HaXoR wrote:

wala258 wrote:skn auz naman.. ginawa ko to.. wala namang problema, naging maganda at dumulas ung cube lalo na pag nalube na ito..

wat materials did u use?

driller tapos box na inukit specialy for single layer sa 3x3x3....

amoy sunog ung cube pagtapos... haha

wat box po? pls specify how to do and wer d get it

box po ng sapatos ung makapal na parte nun ang kunin mo..

i think i'll just buy another core kung ma-loose thread man e may back-up ako hihihihhi... nid kasi natin ang friction to break in e... so ndi pede ang lubricant or coolant... i'm not sure though

i think this should be done on non DIY cubes....

kuya russell post ka nmn pics